Kontak Kami

( pcs) Checkout

Toko Offline Jakarta : Jl. Tanjung No. 14, Jati Pulo, Palmerah, Jakarta Barat WA 082220461544 / 08156085524 Toko Offline Surabaya : Jl. Gebang Lor No.29 (dekat Bundaran Kampus ITS) Telp 031-58201269 WA 085755451067 / 081515513353 Toko Offline Bandung : Jl. Aceh No.24A Pasar Besi Kebon Sirih Telp 022-20528110 WA 081289509963 / 085850845043 Toko Offline Semarang : Jl. Tembalang Baru V No.83 Perumda Tembalang ( depan universitas diponegoro dan POLINES ) WA 081238841477 WA 08121314327
Beranda » Arduino Shield » 16 Channel 12 bit PWM / Servo Shield

16 Channel 12 bit PWM / Servo Shield

Ditambahkan pada: 25 Juni 2018 / Kategori:
Kode : -
Berat : 100 gram
Stok : Ready Stock (30 pcs)
Dilihat : 57 kali
Review : Belum ada review
Rp 140.000
Tentukan Pilihan!

# 16 Channel 12 bit PWM / Servo Shield

Berhasil ditambahkan ke keranjang belanja Anda
Lihat keranjang Anda
Lanjut Belanja
Checkout
Pesan melalui SMS? Klik SMS
Bayar di tempat? Klik COD

Bagikan informasi tentang 16 Channel 12 bit PWM / Servo Shield kepada teman atau kerabat Anda.

Deskripsi 16 Channel 12 bit PWM / Servo Shield

You want to make a cool robot, maybe a hexapod walker, or maybe just a piece of art with a lot of moving parts. Or maybe you want to drive a lot of LEDs with precise PWM output. Then you realize that your microcontroller has a limited number of PWM outputs! What now?

Using only two pins, control 16 free-running PWM outputs! You can even chain up 62 breakouts to control up to 992 PWM outputs

It’s an i2c-controlled PWM driver with a built in clock. That means that, unlike the TLC5940 family, you do not need to continuously send it signal tying up your microcontroller, its completely free running!

It is 5V compliant, which means you can control it from a 3.3V microcontroller and still safely drive up to 6V outputs (this is good for when you want to control white or blue LEDs with 3.4+ forward voltages)

6 address select pins so you can wire up to 62 of these on a single i2c bus, a total of 992 outputs – that’s a lot of servos or LEDs

Adjustable frequency PWM up to about 1.6 KHz

12-bit resolution for each output – for servos, that means about 4us resolution at 60Hz update rate

Configurable push-pull or open-drain output

Output enable pin to quickly disable all the outputs

We wrapped up this lovely chip into a breakout board with a couple nice extras

Terminal block for power input (or you can use the 0.1″ breakouts on the side)

Reverse polarity protection on the terminal block input

Green power-good LED

3 pin connectors in groups of 4 so you can plug in 16 servos at once (Servo plugs are slightly wider than 0.1″ so you can only stack 4 next to each other on 0.1″ header

“Chain-able” design

A spot to place a big capacitor on the V+ line (in case you need it)

330 ohm series resistors on all the output lines to protect them, and to make driving LEDs trivial

Solder jumpers for the 6 address sele

 

Belum ada review untuk 16 Channel 12 bit PWM / Servo Shield

Silahkan tulis review Anda

Alamat email Anda tidak akan dipublikasikan. Ruas yang wajib ditandai *

*







SIDEBAR